Linar Audio

Linar 500 Monaural Balanced Amplifier

Output power at 8ohms 500 Watts
Output power at 4 ohms 1000 Watts
Output power at 2 ohms 2000 Watts
Total harmonic distortion 20-20khz
worst-case 0.4% (typically 0.05%)
Total intermodulation distortion
typically 0.05% with combination
of any 2 frequencies - Note 1
Noise -110 db below max power
Frequency response 1Hz-250KHz +0-3db
Input impedance 53.3 Kohms
Output impedance 0.016 Ohm
Damping Factor Better than 500
Input sensitivity RCA inputs 1.5Volts Rms
(for max power)
Balance input sensitivity 0.75Volt Rms
(for max power)
Gain 30 time the input signal or 29db
Slew rate - Note 2
Class of operation A, AB
Power consumption in idle 20.5 watts
Mass 65 Lbs with packaging
Dimensions 18”x7x15.25” (LxHxD)
Warranty 3 years parts and labor*

Note1 - According to IHF-A202 standard for the purpose of this standard F1 shall equal 60hz,and F2 shall equal 7000hz the low frequency sine wave having an amplitude 4 times greater than that of the high frequency sine wave. The measurement of Linar amplifiers are in respect of this standard even with any frequency combination in any ratio.
TIM is a form of dynamic intermodulation distortion that may be associated with feedback amplifiers that use internal lag compensation.

Note2 - as the amplifier doesn’t use any global feedback the slew rate is irrelevant

All measurements carried out with 120 AC line voltage.

At Linar Audio we are constantly trying new design ideas to improve our products, therefore we reserve the right to change or modify product specifications without notice or obligation

*There may be a small fee to transfer the warranty to subsequent owners.
Contact us with the unit's serial number for more info.
.